The extent of necessary repair work in DIY upholstery often remains unknown until the hard work of deconstruction is done – a scary prospect for some… you might be asking yourself “Will this be a total waste of my precious time?” But in truth the furniture that really is a waste of your time is usually obvious from the outset. For example, it will be apparent during the initial evaluation if any of the supporting rails, styles, posts or legs are broken beyond repair.
Now that you have the piece down to the ‘bare bones’ or at least down to its ‘skivvies’ you’re ready to clean the exposed wood and/or metal parts, tighten or replace screws or bolts, re-glue separated joints and do any refinishing you decided on in Step 1 – Evaluation. You can now clearly see and evaluate the frame and foundation elements, such as springs, webbing & platform wood.
Springs may be reinforced in a variety of ways, or replaced altogether with new springs or a comfortable seat foam. Your options will depend on your chair’s particular construction.
Wood joint failure may be the result of age, stress beyond intended use, exposure to moisture or design flaw.
Here you may find helpful advice from a professional woodworker or furniture restorer if you are unsure of how to proceed. Every chair will present its own unique challenges in the restoration process. These are just a few common situations you may encounter.
Built-up dirt and grime on the exposed wood or metal parts of the frame can be cleaned up with a commercial ‘green’ cleaner (see how top companies rate for chemical safety) or a homemade green cleaner. Always test your cleaner on an inconspicuous area of finished wood surface to be sure it doesn’t cause permanent discoloration (for example some lacquer finishes may turn white when wet).
If you decided to paint or refinish your chair frame, now is the time to break out the spray paint or strip the old finish and apply a new coat of whatever you have chosen to use.